QuickCAM 2D v2.15 released 22nd September 2026
Posted: Tue 22 Sep , 2026 10:32 am
QuickCAM 2D v2.15 released 22nd September 2026
Version 2.14 was an unreleased test version.
There is a retraction height added to the post processor page of the wizard. It defaults to the value in the post processor file selected (Normally 2mm in the Denford files) but this can then be modified by the user.
There was a small bug where a cutting path strategy could be saved, and then if a path is deleted and the file saved, the next time it is loaded might produce an error of 'Unknown argument'. This has been resolved and no error will be produced.
As usual - check here for the latest version:
QuickCam:
http://denfordata.com/downloads/QuickCA ... nv2.15.zip
Version 2.14 was an unreleased test version.
There is a retraction height added to the post processor page of the wizard. It defaults to the value in the post processor file selected (Normally 2mm in the Denford files) but this can then be modified by the user.
There was a small bug where a cutting path strategy could be saved, and then if a path is deleted and the file saved, the next time it is loaded might produce an error of 'Unknown argument'. This has been resolved and no error will be produced.
As usual - check here for the latest version:
QuickCam:
http://denfordata.com/downloads/QuickCA ... nv2.15.zip