Denford Software & Machines

Hello recently i saved Mirac 2000 from scrap, but there is some things not working,
first the nummber

CHOR is disconnected

60 and 61 has no power the ok light do not light up

and it dosent boot

does somebody have the schematic or what software to use?

So update, the power supply for 24 v ir dead, there is mosfet and some balast or shunt resistors blown, the mosfet is around eur, but im not shure if it is the only problem, so to not waste time and money just ordered new din rail 24v 100w power supply.

The next is when i inject power to 24v the eurostep controller shows L, so maybe limit switches. Of course i first measured the battery it is dead, so configurations are lost, removed the battery cleaned the green traces, sop-8 chips that is near have cracks in solder. So maybe it is possible to use the mint 3.28 , i can read the eprom if it helps. But problem starts with where to get program to test the lathe with mint?

So any suggestions where to get the software?

Ok i managed to get to symbol 8 or B, what next