Easimill PNC Sensors

bradders · Thu 05 Jul , 2007 13:58 pm

Does anyone know the sensor details for Easimill PNC axis sensors, NPN or PNP, 2 or 3 wire, Voltage etc

Triac whizz · Thu 05 Jul , 2007 18:43 pm

I can give you a starter for 10 - they're 2 wire if the Easiturn is anything to go by...

I'll have a look see if I've still got the original ones...

Triac whizz · Thu 05 Jul , 2007 18:59 pm

You're in luck! I found one and stuck it on my RS proximity switch tester and it seems to indicate that it's PNP (assuming I connected the 2 wires in the right place

(I'm not an electronics guru but I know what an electrolictic capacitor looks like - even if I can't spell it

)

Voltage? dunno but it works with the RS thingy which uses 9v....

any use?

bradders · Fri 06 Jul , 2007 7:23 am

Cheers Triac Whizz, after a lot of searching I found some in stock (BI00401A) and you are right they are 2 wire devices

Triac whizz · Fri 06 Jul , 2007 22:16 pm

Cheers Traic Whizz

No worries, i see you have one of those dsylexic keyboards

Good job you didn't print the stickers for the machines

you can call me TW

bradders · Mon 09 Jul , 2007 7:11 am

Fridays ! What can i say ?

Information